Home › Forums › Rod Squad Advice Forum › Fly Rods
Posted on: Mon, 11/15/2010 - 20:07
Fly Rod Blank conversion to Spinning rod

I have a fiberglass blank FL 1089, 2 piece that I would like to make into a spinning rod. I was looking for a recipe that someone might suggest for guides and spacings. I know the conversion is possible, but what line rating do you think should be placed on this blank. I appreciate your time. Thank you!

BB


Posted on: Thu, 11/18/2010 - 09:25 #1
I would suggest you run

I would suggest you run 8-12lb test on the rod.

Josh Cooper
Lamiglas Rod Squad Guru

Posted on: Thu, 11/18/2010 - 18:16 #2
Josh, Do you have a

Josh,
Do you have a suggestion on guides and spacing for this rod blank.
Thanks

BB

Posted on: Fri, 11/19/2010 - 11:56 #3
Josh, what would you suggest

Josh, what would you suggest for guides and guide spacing be for this blank.
Thanks.

BB

Posted on: Tue, 12/21/2010 - 10:45 #4
I would go with the same

I would go with the same spacing and sizing as the G1325 listen in the link below.
http://www.lamiglas.com/2010_guide_spacing_chart.pdf

Josh Cooper
Lamiglas Rod Squad Guru

Fly Rods Salmon and Steekhead Rods Bass Rods Freshwater Rods Surf Rods Saltwater Rods

HOME | RODS | BLANKS | MATERIALS | SHOP | PRO-GUIDES | DEALERS | ABOUT | PRESS | WARRANTY | ROD SQUAD | CONTACT US

LAMIGLAS POLICIES: TERMS OF SERVICE | PRIVACY | SHIPPING

COPYRIGHT © 2013 Lamiglas. ALL RIGHTS RESERVED

Proudly Developed by BDC Advertising